| |
|
|
| |
|
|
Vivaneers™ No-Prep Veneers
|
|
|
- PDF Documents
- Tech Notes
- Indications
- Preparation
- Cementation
- Working Time
- ADA Codes
TECHNICAL NOTES
If an adjustment is required on the ceramic, ALWAYS BOND INTO PLACE BEFORE PROCEEDING, then use a fine diamond with water and air to keep the crown cool. To contour the ceramic, polish with a pink rubber wheel and diamond polishing paste (Brassler, Shofu and Vident).
Caution: Do NOT attempt to fire porcelain. It must be done in precisely calibrated ovens at special temperatures and vacuum settings. For best results, return veneer for reglaze firing to lab.
|
INDICATIONS / CONTRAINDICATIONS
Vivaneers are indicated for patients who request to enhance esthetics of their teeth without any need for shots, drills or pain. No-preparation veneers are indicated for patients who have teeth that are lingually inclined or have smaller than normal sized teeth (peg laterals). It can also be used for bonded full crowns, three-quarter crowns and veneers.
Patients with malfunctional occlusion such as bruxers or clenchers should be warned that they stand an increased chance of fracture even if the veneers do not involve the incisal edge.
Patients and dentists must realize that adding additional facial dimension to unprepared teeth (even as little as 0.3 mm) can yield limited esthetic results that can be improved upon by traditional veneer preparation technique.
|
PREPARATION
For optimum esthetics, provide the current shade of the existing tooth, preparation or stump shade along with the final desired shade of the restorations. Slight preparation of the protruding areas with a disc or fine diamond will facilitate in allowing the ideal facial alignment. Minimum Prep - 0.3 mm reduction.
|
CEMENTATION
Adhesive bonding material such as:
Variolink Veneer (Ivoclar Vivadent) Recommended due to its thin, palpable consistency
Scotchbond Multi-Purpose Plus (3M ESPE)
Choice (Bisco, Inc.)
Insure (Cosmedent, Inc.)
CEMENTATION INSTRUCTIONS
Use pumice to clean tooth surface, rinse with water and dry.
Etch tooth surface and clean with water and dry.
Put adhesive bonding material on the tooth as well as the inside of the veneer.
Cure with a curing light. Cure each tooth for at least 30 seconds.
Clean off excess bonding material.
|
WORKING TIME
5 Days In-lab
Rush Cases : All rush cases must be prescheduled by calling 800-944-7874 before the case is shipped. Time of pickup and delivery may affect turnaround time.
|
CODES
D2962 Labial Veneer
|
|
| |
|
|
|
|
|
