| |
|
|
| |
|
|
BioTemps® Provisionals |
|
|
- PDF Documents
- Tech Notes
- Indications
- Preparation
- Cementation
- Working Time
- ADA Codes
TECHNICAL NOTES
Can be fabricated with pre-operative or prepared models.
All shade guides are compatible and we can stain BioTemps to match.
REINFORCEMENT OPTIONS
Wire reinforcement
Kevlar/Fiber Reinforcement
Cast Metal (non-precious) Substructure/Framework
RECOMMENDED RELINE MATERIAL
Cold-cured methyl methacrylate
Jet Acrylic
Cold Pac by Motloid
Palavit 55 by Kulzer
Customers should avoid any composites and ethyl methacrylates like Trim or Snap. Those materials only have a semi-chemical bond to the BioTemp material.
When repairing broken BioTemps chairside, only methyl methacrylate should be used. The customer should remove the glaze by roughing up the surface with a coarse bur. Then apply cold cured methyl methacrylate to the surface.
REGLAZING INSTRUCTIONS
Roughen temps with pumice.
Rinse and dry with air.
Apply a thin layer of palaseal going in one direction.
Bench dry for 20 seconds (air dry).
Polymerize for 90 seconds with hand held curing unit (a light box works best, but hand held light can be used with 2 cycles of 90 seconds on each surface).
|
INDICATIONS / CONTRAINDICATIONS
Indicated for provisional splinted crowns and full-arch bridges. Cast-metal substructure is indicated when pontic span is greater than 3-units. Other indications include immediate smile makeovers, restoring lost vertical dimension, contoured healing for ovate pontics or anterior extractions, or in conjuction with perio treatment. BioTemps come backed with a six-month warranty against breakage. BioTemps are provisional crowns and bridges, which last up to six months. For a longer time frame, Transitional Crowns & Bridges would be indicated.
|
PREPARATION
No preparation is needed for BioTemps. However, existing preparation of any type can be used.
|
CEMENTATION
Non-Eugenol Cements (Easier to remove and lessens thermal sensitivity.)
TempBond (NE) (Kerr)
Eugenol Cements (More permanent and harder to remove.)
Provolink (Ivoclar)
Proviscell (Septodont)
BioTemps Veneers
Spot bonding with a dual cure resin
|
WORKING TIME
5 Days In-lab
6 Days In-lab BioTemps with Cast Metal Substructure
6 Days In-lab BioTemps screw retained over implant case
Rush Cases : All rush cases must be pre-scheduled by calling 800-944-7874 before the case is shipped. Time of pickup and delivery may affect turnaround time.
|
ADA CODES
D2932 Prefabricated Resin Crown
D2970 Temporary Crown
|
|
| |
|
|
|
|
|
