| |
|
|
| |
|
|
PlaySafe® Mouthguards |
|
|
- PDF Documents
- Tech Notes
- Indications
- Preparation
- Cementation
- Working Time
- ADA Codes
TECHNICAL NOTES
We need upper and lower models, including a bite registration of 3 mm thickness at a rest position. (This lets the tech adjust the mouthguard to the patient´s proper vertical.) We can proceed without a bite, but the doctor may need to adjust the mouthguard if it is hitting on the posteriors first. To get the most accurate oral fit, we need an opposing model and bite. We can make without an opposing, but the doctor may need to do adjustments and there would be no cuspid indentation.
Helmet straps are available in black and light red. Please note, the helmet strap should never be used to remove the appliance from the mouth. It is meant to break away if pulled on hard. The patient should always use their fingers to break the seal between the mouthguard and the teeth.
Adjustments:
If an adjustment is required, the doctor may use an arbor band disc to adjust and then repolish with a butane flame. To re-attach a helmet strap, heat the end of the strap, insert into mouthguard's keyway and then hold until cooled off. If there are any further questions or if a serious adjustment is needed, it is recommended to send the mouthguard back to the laboratory.
Ensure an accurate impression of all soft and hard tissue areas, especially the vestibule and peripheral areas. Capturing the vestibule areas is critical as this helps with proper retention and protection.
If a mouthguard is made for a patient with orthodontic brackets, the arch wire must be removed to allow for accurate impression. Or we can block out the brackets and wire prior to fabrication.
Recommended Cleaning Instructions:
- Brush and floss your teeth before placing the appliance in your mouth.
- Clean your appliance after every use with a denture toothbrush and toothpaste under cool water. We recommend Dentu-Crème® or Fresh ’n Brite®. If a white film starts to form or to eliminate odors, soak appliance in denture cleaning solution (Polident®, Efferdent®).
- After cleaning, rinse appliance under cool water. Completely air dry before storing.
DO NOT soak the appliance in mouthwash or alcohol. DO NOT place in hot or boiling water or expose to excessive heat, as this will distort the appliance.
WEB LINKS
For more information, We recommend Julian Hodges', Mouthguards & Sport Safety, or this distributor in the UK, PlaySafe Mouthguards.
|
INDICATIONS / CONTRAINDICATIONS
PlaySafe is indicated for patients who desire protection during sports activity to prevent dental trauma, such as fractured teeth or concussions. It is ideal for those who have an orthodontic situation, such as braces, and must wear a mouthguard for preventative measures.
PlaySafe mouthguards should not be used in lieu of nightguards or TMJ splints.
|
PREPARATION
Start with an accurate bite registration and void-free impression using a custom tray.
|
CEMENTATION
No cementation necessary.
|
WORKING TIME
4 Days In-Lab
Rush Cases : All rush cases must be pre-scheduled by calling 800-944-7874 before the case is shipped. Time of pickup and delivery may affect turnaround time.
|
ADA CODES
D9941 Fabrication of Athletic Mouthguards
|
|
| |
|
|
|
|
|
